Using Firstspot As a bridge

[gpilot]

Hi, We're just about to put a firstspot box on a new merged network with the current system:

IP Router (Internet) 10.0.0.1
Network (Lan) 10.0.0.x

Now i've tried to give the firstspot box the following:

Int Car 10.0.0.2 and ext card 10.0.0.3 but an error saying that they cant be on the same subnet appeared.

Is there anyway to complete this without changing the IP on the router?

Thanks,

G

[alan]

FirstSpot can only act as router instead of a bridge.

On a side note, if you want to have two-way communication between both side of the networks, you can turn off NAT within FirstSpot.
_________________
~ Patronsoft Limited ~