Cant navigate

[manuel]

mhm, i've turned off the AP as DHCP, but i don't get any ping. The AP has no IP forwarding, i've to need, do i???

The AP has two ports, WAN and LAN. How can i connect otherwise to the server?? I don't understand what you mean with this...

[alan]

Again, use LAN port instead of WAN. This will make your AP acts as a bridge instead of a router. You might refer to some networking documentation for the differences.
_________________
~ Patronsoft Limited ~

[manuel]

i've found the mistake. Although the firewall was switched off, it blocked the ports.

http://www.patronsoft.com/forum/viewtopic.php?t=1084
I have the facility to open the port per Special Apps. But i don't know, are they the incoming ports?? What should i fill in in the trigger port??

thx for response

[alan]

Yes, they are incoming ports for the FirstSpot machine.
_________________
~ Patronsoft Limited ~

[manuel]

yes, but which ports do they use on the clients??

i get messages on my AP:
Blocked access attempt : TCP from 10.20.7.1:5786 to 10.20.7.11:1078
Blocked access attempt : TCP from 10.20.7.1:5786 to 10.20.7.11:2177
Blocked access attempt : TCP from 10.20.7.1:5786 to 10.20.7.11:2281
Blocked access attempt : TCP from 10.20.7.1:5786 to 10.20.7.11:3101

i think, 5786 is the trigger port and 1000-4000 the incoming ports, am i right???

[alan]

Sorry my mistake, it should be both incoming and outgoing ports (from FirstSpot machine point of view).
_________________
~ Patronsoft Limited ~

[manuel]

i tried to take the LAN port, but i cannot config the AP for this case.

Do you have another idea??