disable nat and create user account

[pokam]

I have 3 problem

1)first problem

I install firstspot on PC1 and pc1 is connected on switch, this switch is connected on router and router is connect on internet
public addres nic card of pc1 is 192.168.20.2
private address nic card of pc1 is 192.168.20.5
i desabled NAT
when i save there is no problem
when i restart firstspot i have this message

Mon Sep 12 18:06:28 2005 ***** All the error messages of session started at Mon Sep 12 18:06:28 2005 are shown below *****
Tue Sep 13 07:56:04 2005 ***** All the error messages of session started at Tue Sep 13 07:56:04 2005 are shown below *****
Tue Sep 13 08:15:27 2005 ***** All the error messages of session started at Tue Sep 13 08:15:27 2005 are shown below *****
Tue Sep 13 11:13:14 2005 ***** All the error messages of session started at Tue Sep 13 11:13:14 2005 are shown below *****
Tue Sep 13 11:13:16 2005 The Private Network Interface and Public Network Interface network segments are overlapped (therefore FirstSpot's routing won't work). Please change the IP address


How to resolv this probleme

2) second problem
I configure timeout to 60
But user account disconnect on client PC after 10 min every time


3) third problem
how to generate user account automaticaly

thank's

[alan]

1) Your problem is unrelated to NAT. See http://www.patronsoft.com/forum/viewtopic.php?t=625 for details.

Also, note that you need setup the return route in your router in the next hop if you disable NAT within FirstSpot.

2) There is a 15 minutes per session limit for the trial version. See http://www.patronsoft.com/firstspot/editions.html for details.

3) You can use the Bulk Accounts creation tools within Configuration Manager.
_________________
~ Patronsoft Limited ~